Sandbox:CombustionEngine

STEP 1: Enable the connectors to cold loop pump, and the cooling array to generator pump, to get the cold loop circulating.

STEP 2: Configure the gas mixer to output north, and inject the contents of as many hydrogen and oxygen tanks into the combustion chamber as you wish, at the pre-set ratio of 60% oxygen and 40% hydrogen.

STEP 3: Disable injection! Do not leave injection on!

STEP 4: Ignite the mix inside the combustion chamber, and wait for it to fully burn out. Some strain on the glass at this step is expected.

STEP 5: Once the fire has stopped and the contents of the tank are 100% CO2, enable circulation: I recommend 700L/s input and 1000kpa output. The higher you put the output, more power it generates, raise as necessary.

WARNING: If you feel it's going to break the glass, lower the blast doors and vent the chamber immediately! We have a portable generator in the back if we run out of fuel or suffer another mishap.